The old boiler at this Guildford property was beginning to fail, so we replaced it with a new Worcester Bosch gas boiler. The installation photo shows something we rarely get to see in a standard boiler shot. Alongside the new appliance are a hot water cylinder, a circulation pump and several other components, each doing a different job.
The large white cylinder on the right is a Heatrae Sadia Megaflo. While the boiler provides heat, the cylinder stores hot water ready for the taps and showers. The smaller components help move the heating water, manage pressure and keep debris out of the boiler.
| What you can see | What it does |
|---|---|
| Small red unit above the black canister | Circulation pump. Moves heating water around the system. |
| Large red vessel at the top right | Expansion vessel. Gives water room to expand as it heats up, helping keep pressure stable. We’d trace the pipework to confirm exactly which circuit it serves. |
| Black canister below the pump | A magnetic system filter. It collects iron debris carried by the heating water before it can build up inside the boiler. |
| Small round dial beside the filter | Pressure gauge. Shows the pressure in the circuit it’s connected to. |
| Grey wired fittings low beside the cylinder | Motorised valves. These open and close to control water flow to circuits such as the radiators and the cylinder. |
A garage or outbuilding can shelter the boiler from the rain while still getting cold enough for its pipework to freeze. One pipe we pay particular attention to is the condensate drain. It carries away the water a condensing boiler produces during normal operation. If that water freezes in an exposed section and blocks the drain, the boiler can shut down. Exposed water pipes can also split when they freeze, with a leak sometimes becoming apparent only as they thaw.
Built in frost protection can help protect the boiler itself, provided it has power and can operate. Pipework elsewhere in the outbuilding may need its own protection. When we assess an installation in an unheated space, we look at how the exposed pipes are insulated, where the condensate drains and whether the system needs additional frost controls.
If you’re weighing up a replacement, you can get a guideline price with our online boiler quotation tool. We can visit to assess your existing setup and provide a full estimate.
Yes, where the location meets the boiler manufacturer’s installation requirements. We check the flue route, access for servicing, condensate drainage and how the boiler and exposed pipework will be protected from frost.
If the boiler stops during a cold spell, a gurgling sound or a fault code can be a clue. The code depends on the boiler model, so check the manual or ask us to help identify the fault.
No. Built in frost protection needs electricity. If you’re going away during a cold spell, check the boiler and controller instructions for the settings that keep frost protection active.
Often, yes. We check the cylinder’s condition and whether it’s compatible with the replacement boiler and controls. An existing cylinder in good condition may be suitable to keep.

Nick Parris has more than 25 years of experience in plumbing, boiler installation and heating services, helping homeowners across Reading and the surrounding areas keep their homes warm, efficient and reliable.
As a Gas Safe registered heating engineer and Worcester Bosch accredited installer, Nick combines practical, hands on experience with straightforward advice. Our Help and Advice articles are written to give homeowners clear, useful information based on the questions and heating problems we deal with every day.